Anthro eNook Standard Spécifications télécharger pdf (Page 5)

eNook

Assembly Instructions

STEP 8

Install one TOGGLER™ for Drywall Installation

¡ Drill 1/2” diameter hole in your wall at the mounting

point.

¡ Insert a TOGGLER into a hole, metal end ﬁrst.

¡ Pull the plastic ring end so the metal channel rests

ﬂush behind the wall. With your other hand, slide the

plastic cap along the straps until the ﬂange of the cap

is ﬂush with the wall.

¡ Place your thumb between the plastic straps. Push

side to side, snapping off the straps at the wall.

¡ Insert a 1-5/8" long screw into the TOGGLER, but don’t

tighten all the way. Leave the bolt head about 1/4”

from the plastic cap.

STEP 9

Install remaining TOGGLERs

This is a two-person step!

¡ Lift the eNook Frame onto the bolt. Using a level to

make sure that the Frame is level, mark the second

mounting point as shown. Be sure that you mark your

spot in the center of the small keyhole!

¡ Mark the third and fourth mounting points along the

bottom hole array. Set aside the Frame.

¡ Drill 1/2” diameter holes on the 2nd, 3rd, and

4th mounting points and install TOGGLERs as

instructed above.

B C

1 2 3 4 5 6 7 8 9

Pas de commentaire

Anthro eNook Standard Spécifications Page 5