Anthro eNook Standard Spécifications télécharger pdf (Page 7)

eNook

Assembly Instructions

STEP 13

Insert the Bottom Tray

¡ Place the Bottom Tray on the eNook shelf

so that the logo on the tray faces out.

¡ Align the 2 holes on the back of the

Tray with the pins on the Frame.

¡ Slide the Tray into place. Attach the tray

to the left and right of the frame using 4

workstation screws. Do not tighten these

screws all the way.

¡ Install the cover plates, one on the left

and one on the right of the Tray. Slide

each Plate over the two workstation

screws, then down to insert the tabs on

the Plate into the notches on the Tray.

Tighten the workstation screws.

STEP 14

Insert the Back Panel

¡ Hold the Back Panel so that the fabric-covered

side is facing you, long side up.

¡ Place the Panel into the eNook so that the bottom

edge is resting on the bottom of the frame.

¡ Tip the top of the Panel into place and secure with

the Tack Board Clip and a 3/8" Phillips head screw

inserted through the top of the Frame.

Pins

Workstation Screw

325-5092-00

3/8" Phillips Head Screw

325-5172-00

Tab

Notch

1 2 3 4 5 6 7 8 9

Pas de commentaire

Anthro eNook Standard Spécifications Page 7